- Access exclusive content
- Connect with peers
- Share your expertise
- Find support resources
08-23-2013 04:21 PM
The issue is very rare and is most likely happens due to the Dataplane being extremely busy when writing to the traffic log. The log gets corrupted when being written. In the traffic logs, Start Time is generated by Dataplane and Receive Time is generated by Management Plane. Also then the question comes why did it pick year 2031 i believe because the end time of unix for 32 bit systems is 2031. I don't believe there is any fix for this issue. This an event where a single log entry got corrupted.
Hope this helps you understand why you saw this.
Thank you
Numan
08-23-2013 01:54 AM
Hello
This is a known issue. I would recommend you to open a case with the support.
08-23-2013 01:59 AM
If you have just seen this issue. I would recommend you to follow the steps below which will help the support team to troubleshoot further.
> show session all filter source <SRC-IP> destination <DST-IP>
> show session id {#id of the session in step1}
Upload the putty logging outputs and screenshots.
08-23-2013 04:21 PM
The issue is very rare and is most likely happens due to the Dataplane being extremely busy when writing to the traffic log. The log gets corrupted when being written. In the traffic logs, Start Time is generated by Dataplane and Receive Time is generated by Management Plane. Also then the question comes why did it pick year 2031 i believe because the end time of unix for 32 bit systems is 2031. I don't believe there is any fix for this issue. This an event where a single log entry got corrupted.
Hope this helps you understand why you saw this.
Thank you
Numan
08-26-2013 01:34 AM
Say good bye to the Y2K problem, say hello to Mr 2031 😃
10-17-2013 01:36 AM
Fixed in 5.0.8
54347—Extremely large amounts of traffic (Exabytes, or Billions of Gigabytes) were
showing up in the ACC tab and logs for users. An issue where the date of record
showed as starting in 2031 caused the incorrect counter of traffic, due to the date being
set in the future. Date verification is now supported to prevent this from occurring.
10-17-2013 02:54 AM
Those high numbers also show up in reports...
10-17-2013 03:03 AM
Not that I know, we're not on 5.0.8 yet...
Click Accept as Solution to acknowledge that the answer to your question has been provided.
The button appears next to the replies on topics you’ve started. The member who gave the solution and all future visitors to this topic will appreciate it!
These simple actions take just seconds of your time, but go a long way in showing appreciation for community members and the LIVEcommunity as a whole!
The LIVEcommunity thanks you for your participation!