Source-NAT with POOL from GlobalProtect zone to subnet behind the MPLS router

cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
Announcements

Source-NAT with POOL from GlobalProtect zone to subnet behind the MPLS router

L1 Bithead

Hi community, 

I'm writting this post to get any ideas or suggestions in a new end-customer requirement. The main goal is that all clients connected via GlobalProtect can access to a new services acquired recently via MPLS (attached the brief topology). The point here is the MPLS's administrator share a specific IP Address that we need to NAT any source address from the Firewall Palo Alto. 

 

We asigned the 192.168.130.0/24 pool to dynamic-client and we need to get access to 172.21.2.9 through out MPLS and it indicates us we have to NAT with 192.168.1.222 IP address; the config applied works, the traffic from the dynamic-client to 172.21.2.9 leave the firewall with 192.168.1.222 but, we can't connect and the session detail shows "application = incomplete/undecided"

 

This is the brief flow-traffic:

larry2019_0-1665525816825.png

 

In advanced, thank you so much for your reply!

 

 

 

1 REPLY 1

Cyber Elite
Cyber Elite

Hello,

Make sure the policies are marked with 'Log at session end'. Then check the logs to see if any traffic is getting blocked. Could be a misconfigured security policy.

Regards,

  • 1125 Views
  • 1 replies
  • 0 Likes
Like what you see?

Show your appreciation!

Click Like if a post is helpful to you or if you just want to show your support.

Click Accept as Solution to acknowledge that the answer to your question has been provided.

The button appears next to the replies on topics you’ve started. The member who gave the solution and all future visitors to this topic will appreciate it!

These simple actions take just seconds of your time, but go a long way in showing appreciation for community members and the LIVEcommunity as a whole!

The LIVEcommunity thanks you for your participation!