11-05-2024 01:03 AM
hello all
I am working on a BGP configuration on a HA 3220 series install
the BGP status is staying at connect not establish
I enabled BGP on the IP addresses inbound /outbound -- no hits on the policy
Q are there show commands or debugs that can help me determine what the issue is ?
many thanks
11-05-2024 01:41 PM
Hello @S.Byrne
thanks for post.
If the peer status is stuck in "connect" state, then this BGP peer was likely not able to complete TCP 3-way handshake. Could you check below steps:
- If you configured policy with application BGP, try to replace it with service TCP 179.
- Check whether update source IP address and peering IP address is correct on both sides of devices peering with each other.
- Check logs from CLI: less mp-log routing.log for more details.
Kind Regards
Pavel
11-05-2024 01:41 PM
Hello @S.Byrne
thanks for post.
If the peer status is stuck in "connect" state, then this BGP peer was likely not able to complete TCP 3-way handshake. Could you check below steps:
- If you configured policy with application BGP, try to replace it with service TCP 179.
- Check whether update source IP address and peering IP address is correct on both sides of devices peering with each other.
- Check logs from CLI: less mp-log routing.log for more details.
Kind Regards
Pavel
Click Accept as Solution to acknowledge that the answer to your question has been provided.
The button appears next to the replies on topics you’ve started. The member who gave the solution and all future visitors to this topic will appreciate it!
These simple actions take just seconds of your time, but go a long way in showing appreciation for community members and the LIVEcommunity as a whole!
The LIVEcommunity thanks you for your participation!
