PSMP ADBridge: How to enable debugging

cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
PAM Self-Hosted Articles
1 min read
L3 Networker
No ratings
How do I enable debug for PSMP ADBridge?

Steps

1. Log into the vault with the PrivateArk Client as a user with vault administration privileges

 

2. Open the PSMPADBridgeConf safe
3. Right click 'main_psmpadbridge.conf.linux.<version>' and click 'Retrieve and Open'. It should be opened in a text editor. (Note: The version may differ based on the PSMP version installed)
4. Once opened, look for the [Debug] section. It will look like the following:

[Debug]
#CacheDebugLevels=1,2
#AppProviderDebugLevels=1,2,3,4,5
#ADBridgeDebugLevels=1,2,3,4,5
#ProtocolDebugLevels=1,2

5. Uncomment (if not already) the four lines under [Debug]
6. Save the file, right click on the filename and select 'Return to safe'
7. On the PSMP server, run the following command 'sudo service psmpsrv restart'

To turn off PSMP ADBridge debugging, follow the above steps 1 - 7. In step 5, put a '#' in front of the four lines.
Rate this article:
  • 1256 Views
  • 0 comments
  • 0 Likes
Article Dashboard
Version history
Last Updated:
‎09-01-2021 08:01 AM
Updated by: