This article illustrates how to increase the size of /dev/shm on Linux variants to facilitate the proper installation of PTA and PTA Network Sensor
Note:
The manual PTA and manual PTA Network Sensor installation use /dev/shm as temporary storage for installation. This is not applicable when PTA and PTA Network Sensor is imported from the OVF / Hyper-V images
Steps
DISCLAIMER: If the target machine is on a virtual image, it is
HIGHLY RECOMMENDED to take a snapshot of the machine before using this process.
This process involves editing the /etc/fstab and running a command to remount the /dev/shm partition
1. You must be logged into the machine as root or a user with 'sudo' privileges.
2. Make a copy of the /etc/fstab file
3. Open /etc/fstab in a text editor. Look for the following line:
/dev/mapper/centos-dev_shm /dev/shm xfs defaults 0 0
a. In some variants, the line may not be present. If this is the case, add the following line
/dev/mapper/centos-dev_shm /dev/shm xfs defaults,size=3G 0 0
b. If the line is already present as above, add ',size=<size>' after 'defaults', where <size> is the desired filesystem size. A 2GB or 3GB partition is usually sufficient. The above example has a 3 GB size. The line should look like this:
/dev/mapper/centos-dev_shm /dev/shm xfs defaults,size=3G 0 0
4. Save the /etc/fstab file
5. Run the following command: sudo mount -o remount /dev/shm
6. Run the following command: df -h. The output, if configured correctly should look something like this:
[tsawyer@lab-ptasensor ~]$ df -h
Filesystem Size Used Avail Use% Mounted on
devtmpfs 906M 0 906M 0% /dev
tmpfs 3.0G 0 3.0G 0% /dev/shm
tmpfs 917M 9.0M 908M 1% /run
tmpfs 917M 0 917M 0% /sys/fs/cgroup
/dev/mapper/centos-root 41G 1.3G 40G 3% /
/dev/sda1 1014M 150M 865M 15% /boot
/dev/mapper/centos-home 20G 33M 20G 1% /home
tmpfs 184M 0 184M 0% /run/user/0
tmpfs 184M 0 184M 0% /run/user/1000
Note the /dev/shm partition now has 3 GB of space available.