Windows authentication with RADIUS

cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
PAM Self-Hosted Articles
2 min read
L3 Networker
No ratings
The PVWA offers several different methods for users to access the UI.
* Cyberark
* LDAP
* Windows
* RADIUS
* SecurID (RSA tokens)
* PKI
* Oracle SSO

In addition to these, LDAP, Idira and RADIUS can be used as a secondary method to allow for what is popularly known as multi-factor authentication.

This article specifically covers Windows as a primary authentication and RADIUS as the secondary method

Steps

1. RADIUS authentication from the vault should be configured and verified
2. For Windows authentication, the PVWA must be installed on a machine in a domain where the end user is located
 
Note: Windows authentication differs from LDAP authentication in that the user does not enter a password during the auth process. Once the PVWA has confirmed the user's identity, it either brings up the default interface, or it will prompt them for another set of credentials (if a secondary authentication method has been configured)

3. In the PVWA, go to Options -> Authentication Methods.

a. Select "Windows".

  • Change "Enabled" to "Yes".
  • Change "UseVaultAuthentication" to "Yes".
  • Change "UseRadius" to "Yes"

b. Click "Apply" and "Ok"

To test:
1. The end user should be logged into a machine on the domain
2. Open a browser, navigate to the PVWA URL
3. Select "Windows" as the authentication method
4. In the login screen, the user ID should be pre-populated. At this point, the user should enter their RADIUS credentials.

If everything is correct, the user should be logged into the PVWA at this point

Rate this article:
  • 3782 Views
  • 0 comments
  • 0 Likes
Article Dashboard
Version history
Last Updated:
‎11-05-2026 12:08 PM
Updated by: