SDWAN interface configuration in template

cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
Announcements

SDWAN interface configuration in template

L0 Member
Commit fail:
Details:
. Validation Error:
. network -> interface -> sdwan -> units -> sdwan.100 -> interface 'ethernet1/1' is not a valid reference
. network -> interface -> sdwan -> units -> sdwan.100 -> interface is invalid
. Error: SD-WAN is not enabled for member interface (ethernet1/1)
. Error: interface configuration error
. (Module: device)
. Commit failed

However SD-WAN is enabled on ethernet 1/1
Enable SD-WAN (check): SD-WAN Interface Status: Enabled
SD-WAN Interface Profile: Hub Internet

Any clues as to where to start troubleshooting this?   Thanks.

1 REPLY 1

L0 Member
network -> interface -> sdwan -> units -> sdwan.100 -> interface 'ethernet1/1' is not a valid reference

If SDWAN checkbox and sdwan interface profile is enabled on interface eth1/1 then that error probably means that somewhere in configuration you are referring to interface ethernet1/1 and the configuration do not know what is it interface "ethernet1/1".

Check your configuration especially if you are configuring ethernet1/1 and sdwan.100 in the same template.

 

If you can not find the error just put your template configuration with sdwan.100 from panorama.

 

 

WK
  • 1717 Views
  • 1 replies
  • 0 Likes
Like what you see?

Show your appreciation!

Click Like if a post is helpful to you or if you just want to show your support.

Click Accept as Solution to acknowledge that the answer to your question has been provided.

The button appears next to the replies on topics you’ve started. The member who gave the solution and all future visitors to this topic will appreciate it!

These simple actions take just seconds of your time, but go a long way in showing appreciation for community members and the LIVEcommunity as a whole!

The LIVEcommunity thanks you for your participation!