EVE-NG PA booting issue

[donphila2006]

Hi all,

I have a eve-ng laptop that i'm planning to use for practice. I have installed the KVM file and activated it as well as added it to the eve-ng lab. However, when i start the device. I get the error message "No bootable Device". This device is currently configured to use PA8.0.5 in the EVE-NG environment. 

I have Attached a screenshot of the boot messages to this post. Please, help me take a look at it and advice what to do. I'm just learning to setup my own EVE-NG lab to start practicing on my own. So, any help will be much appreciated. Also, you can see the booting messages below.

###########################################

.......... No configuration methods s
ucceeded (http://ipxe.org/040ee119)
No more network devices

Booting from ROM...
iPXE (PCI 00:04.0) starting execution...ok
iPXE initialising devices...ok

iPXE 1.0.0+ (0600d) -- Open Source Network Boot Firmware -- http://ipxe.org
Features: DNS HTTP iSCSI TFTP AoE ELF MBOOT PXE bzImage Menu PXEXT

net1: 50:00:00:01:00:01 using 82540em on 0000:00:04.0 (open)
[Link:up, TX:0 TXE:0 RX:0 RXE:0]
Configuring (net1 50:00:00:01:00:01)................. No configuration methods s
ucceeded (http://ipxe.org/040ee119)
No more network devices

Booting from ROM...
iPXE (PCI 00:05.0) starting execution...ok
iPXE initialising devices...ok

iPXE 1.0.0+ (0600d) -- Open Source Network Boot Firmware -- http://ipxe.org
Features: DNS HTTP iSCSI TFTP AoE ELF MBOOT PXE bzImage Menu PXEXT

net2: 50:00:00:01:00:02 using 82540em on 0000:00:05.0 (open)
[Link:up, TX:0 TXE:0 RX:0 RXE:0]
Configuring (net2 50:00:00:01:00:02)................. No configuration methods s
ucceeded (http://ipxe.org/040ee119)
No more network devices

Booting from ROM...
iPXE (PCI 00:06.0) starting execution...ok
iPXE initialising devices...ok

iPXE 1.0.0+ (0600d) -- Open Source Network Boot Firmware -- http://ipxe.org
Features: DNS HTTP iSCSI TFTP AoE ELF MBOOT PXE bzImage Menu PXEXT

net3: 50:00:00:01:00:03 using 82540em on 0000:00:06.0 (open)
[Link:up, TX:0 TXE:0 RX:0 RXE:0]
Configuring (net3 50:00:00:01:00:03)................. No configuration methods s
ucceeded (http://ipxe.org/040ee119)
No more network devices

No bootable device.

[JoeLentz]

Just ran into the same problem.  For me it was because the disk image was missing from the paloalto directory in /opt/unetlab/addons/qemu/ .  Moving the file virtioa.qcow2 into the correct folder fixed it for me.