ACC shows ipv6 addresses in source/destination IP

[RudolfTorvenyi1]

Hello, I have a PA-220 with PANOS 10.1.3 installed. I see IPv6 addresses in source/destination IP widget. It started from 10.1.x version

does anybody has the same issue?

[rmcrae]

Looks like 10.2 just release today at least for the PA220.  In reviewing the release notes I do not see that the IPv6 like addresses in the ACC view where fixed NOR do I see it listed as a known issue.  I'll try and update later tonight and see what it looks like.

[NalimG]

Hi!

Updated last night and now looks ok. And no sign about it in release notes!

[rmcrae]

I updated last night but now I have a new problem.  The FW rebooted as expected after installing the new version of the OS but once it came back up I can no longer reach the management interface.  I have to go to the device now and plug in via the serial interface and see what I can figure out.  I'm not very good with the CLI.  The FW is passing traffic though.

[rmcrae]

Once I set the management interface static I'm able to access the FW again.  I suspect a race condition.  The DHCP service might not be ready to service requests when the interface attempts to lease an address but that's just a theory at this point.

[rmcrae]

EDIT: it's working now.  see later reply.

EDIT again: it's broken again.

I can confirm that this IPv6 like addresses in the ACC tab HAS NOT been resolved in PANOS 10.2 on the PA220
😡

[palokb57]

My PA-820 on 10.2 shows IPv4 addresses as I was used under 10.0.x months ago...will see how long

[rmcrae]

How can you use the malware-test to do this?

[rmcrae]

I'm not sure what has changed but now my PA220 is showing the correct IPv4 address (or resolved node name for those I have mapped in addresses) in the ACC tabs.  Maybe it just took the device a while to clean up information stored in the logs after I updated to 10.2.

[Netzer]

How did you get version 10.2? Panorama doesn't show it yet.

[palokb57]

After less then 24 hours the PA-820 on v10.2 shows again the IPv6 crap.

[palokb57]

Directly on the box GUI. But it shows the IPv4 addresses at ACC for less then 24 hours, now it shows again the IPv6 crap.

Anyway 10.2 ist not a prefered relase: Support PAN-OS Software Release Guidance 

[rmcrae]

Well shoot...

I can confirm that I am also seeing the IPv6 like addresses again on the ACC tab on my PA220.  The update looked promising but apparently it wasn't ready for release.

[rmcrae]

@LAYER_8 what's the inside word?  10.2 does not fix the issue and no mention of it in the release notes.

[rmcrae]

And it's working again.  Something is obviously not stable.

[palokb57]

Here also, currently IPv4 shown in ACC