Aggregate Interface MAC is not Showing in cisco switch

cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
Announcements
Please sign in to see details of an important advisory in our Customer Advisories area.

Aggregate Interface MAC is not Showing in cisco switch

L2 Linker

Hello Everyone,

We have configured LACP between paloalto and cisco switch and Aggregate Interface is showing up at both end but at peer switch its mac address not showing.

 

However physical port of other interface mac address is showing on that switch. Please suggest what is next plan of action.

 

model: PA-5220

sw-version: 9.0.5

RK
5 REPLIES 5

L3 Networker

Hi ,

Can you share the PA end configuration ?

 

We have setup on PA version 9.0.2 and it's working as expected.

 

Thanks 

L0 Member

I have the same problem.

 

Someome find the solution for this issue?

On PA we can see the mac-address of the nei switch.

 

show lacp aggregate-ethernet ae1

LACP:

**********************************************************************************
AE group: ae1
Members: Bndl Rx state Mux state Sel state
ethernet1/21 yes Current Tx_Rx Selected
ethernet1/22 yes Current Tx_Rx Selected
Status: Enabled
Mode: Passive
Rate: Slow
Max-port: 8
Fast-failover: Disabled
Pre-negotiation: Disabled
Local: System Priority: 32768
System MAC: 58:49:3b:93:78:01
Key: 48
Partner: System Priority: 0
System MAC: e8:e7:32:e2:92:e1--------------------connected switch
Key: 2
Port State
--------------------------------------------------------------------------------
Interface Port
Number Priority Mode Rate Key State
--------------------------------------------------------------------------------
ethernet1/21 36 32768 Passive Slow 48 0x3C
Partner 5126 0 Active Fast 2 0x3F

ethernet1/22 37 32768 Passive Slow 48 0x3C
Partner 9222 0 Active Fast 2 0x3F

Port Counters
--------------------------------------------------------------------------------
Interface LACPDUs Marker Marker Response Error
Sent Recv Sent Recv Sent Recv Unknown Illegal
--------------------------------------------------------------------------------
ethernet1/21 10397404 345768 0 0 0 0 0 0
ethernet1/22 10397401 345767 0 0 0 0 0 0

MP

Help the community: Like helpful comments and mark solutions.

Hello,

Thank you for response, but, my issue is thay mac of pc's not is see um arp table on PA.

 

The other side is cisco 3850.

 

 The Mac is visible um all network...in all trunk's but PA not reognize.

 

 

 

@Gilberto1985 

 

when you say your PC mac its mac address is not showing in arp.

How is your mac connected or generating traffic ?

MP

Help the community: Like helpful comments and mark solutions.
  • 4136 Views
  • 5 replies
  • 0 Likes
Like what you see?

Show your appreciation!

Click Like if a post is helpful to you or if you just want to show your support.

Click Accept as Solution to acknowledge that the answer to your question has been provided.

The button appears next to the replies on topics you’ve started. The member who gave the solution and all future visitors to this topic will appreciate it!

These simple actions take just seconds of your time, but go a long way in showing appreciation for community members and the LIVEcommunity as a whole!

The LIVEcommunity thanks you for your participation!