BGP Routing Question

cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
Announcements

BGP Routing Question

L3 Networker

Hi All,

 

I have BGP routing advertising from the Palo with eBGP advertising internally and externally for 4 vSYSs.

 

How do I advertise a particular vSYS with public IP a.a.a.a to advertise it as a route for public IP b.b.b.b/27.

 

Regards

 

Adrian

1 accepted solution

Accepted Solutions

Thanks. I managed to find the issue. As well as adding the subnet into the public facing export rule I needed to add it into the redistribution area. I had a redistribution entry of 0.0.0.0/0 and though that covered it but alas it didn't.

 

Now onto my next issue 🙂

 

Regards

 

Adrian

View solution in original post

2 REPLIES 2

L3 Networker

Need a bit more detail here. But it sounds like you need a redistribution profile.

 

I'm assuming b.b.b.b/27 is going to be used for NAT on your public facing zone? If b.b.b.b/27 is connected or learned via another routing protocol (eg static, ospf), you can configure a Redistribution profile to advertise them to your eBGP public peer.

If b.b.b.b/27 does not exist, then you can manually redistribute it without tieing it to any other interface or routing protocol. This just means your firewall with redistribute it not matter what.

 

Secondly you need to make sure the route filters are in place on your end to allow the redistribution and on the peers end to allow for the learning and further distribution of the b.b.b.b/27 network.

Thanks. I managed to find the issue. As well as adding the subnet into the public facing export rule I needed to add it into the redistribution area. I had a redistribution entry of 0.0.0.0/0 and though that covered it but alas it didn't.

 

Now onto my next issue 🙂

 

Regards

 

Adrian

  • 1 accepted solution
  • 4536 Views
  • 2 replies
  • 0 Likes
Like what you see?

Show your appreciation!

Click Like if a post is helpful to you or if you just want to show your support.

Click Accept as Solution to acknowledge that the answer to your question has been provided.

The button appears next to the replies on topics you’ve started. The member who gave the solution and all future visitors to this topic will appreciate it!

These simple actions take just seconds of your time, but go a long way in showing appreciation for community members and the LIVEcommunity as a whole!

The LIVEcommunity thanks you for your participation!