- Access exclusive content
- Connect with peers
- Share your expertise
- Find support resources
04-07-2023 05:27 AM
Hi
I tried to convert to a advanced routing engine using built in script in version 10.2.4 (pa 440) it converted with the yellow status
after reboot I noticed that non of my static routes work and each static route now has an additional entry for vrf that is not listed in the guide below, put 1 there - it did not make any difference
can somebody please advise
thank you
04-07-2023 04:29 PM - edited 04-07-2023 04:29 PM
04-07-2023 11:09 PM
I have removed dampening profile from bgp it made the conversion script to run ok, got green status at the end however the static routes are still not working, the router engine follows the default route instead of the static route
I think the issue is that line towards the bottom of each static route, no mater what i put there, it never saves, I think it should not be thre in the 1st place in the official palo alto guide it's not there
Click Accept as Solution to acknowledge that the answer to your question has been provided.
The button appears next to the replies on topics you’ve started. The member who gave the solution and all future visitors to this topic will appreciate it!
These simple actions take just seconds of your time, but go a long way in showing appreciation for community members and the LIVEcommunity as a whole!
The LIVEcommunity thanks you for your participation!