debug dataplane process task on debug

[MP18]

below command 

debug dataplane process task on debug

when we should use this command?

what does this command do?

[reaper]

only use this when instructed by TAC to do so

it enabled (this logging is disabled by default) and increases log level to maximum for the dataplane software communications tasks

if used inappropriately it could cause serious side effects

[MP18]

Thanks for replying to the post.

I will not use this command on my own .

So when you say DP communication tasks does it mean with in the DP?

or 

Between DP and MP?

Please explain this.

[MP18]

Also which command will show me the  outout of debug dataplane process task?

[reaper · Accepted solution]

Ok, I feel like you're going to ignore my advice about not touching that command 😛

It is used to debug the traffic debug commands (flow basic Et al.) , so it operates at the lowest level and when the system is under tremendous stress

Enabling it if the conditions are not absolutely ideal will cause serious repercussions (i can't stress this enough)

It is added to the same logfile as flow basic so pan_task_x.log and after aggregation pan_packet_diag.log

[MP18]

Many Thanks Need to learn a lot from you.

[MP18]

I will use this command with great caution.

Check the DP load first  then make sure filters are there for traffic pcap,then flow basic etc.

Will use this at LAB device first.