02-24-2015 12:00 AM
I have purchased two (2) Panorama devices M-100 to be setup in HA-mode.
A couple of questions:
a) There are two interfaces in the front. One for Management, but what is the second one (the one to the right) used for?
b) The devices are "active/passive" or actually "primary/seconday" with a management address of its own. Which address do I put on the firewalls' "Panorama setting"? The primary or secondary?
Sorry for these noob-questions.
//Christer J.
02-24-2015 05:29 AM
Hi,
Other interface is like an secondary interface that you can make use of if you are using 6.1.0 and above. This is used to send other syslog messages if you are forwarding them from Panorama. This is useful in a situation where there are significant load for the single management interface. This is an optional configuration.
It is combination of both. Primary and Secondary describes the priority and Active-Passive defines there current role. To make any changes to firewall from Panorama, Panorama in question needs to be active mode. Unlike regular active passive, you will see prompt
admin@M-100 (primary-active)>
Hope this helps. Thank you.
Click Accept as Solution to acknowledge that the answer to your question has been provided.
The button appears next to the replies on topics you’ve started. The member who gave the solution and all future visitors to this topic will appreciate it!
These simple actions take just seconds of your time, but go a long way in showing appreciation for community members and the LIVEcommunity as a whole!
The LIVEcommunity thanks you for your participation!
