Draytek Vigor - Site to Site VPN

cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
Announcements

Draytek Vigor - Site to Site VPN

L3 Networker

Hi there,

I'm looking to setup a few site to site VPNs using a PA2020 at our HQ site with Draytek Vigor 2830n routers at the other end. We have fixed IP addresses on the other end so I don't need to worry about the issues with dynamic IPs.

I was wondering if anyone has experience with setting them up and if they had any issues getting them up and running. I'll be working through it over the next week or so and hope to post any issues or a full solution should it go ok!

Cheers,

UKRB

2 REPLIES 2

L4 Transporter

Hope this helps.

https://live.paloaltonetworks.com/docs/DOC-1163

If the remote site has static IP addresses, then the PAN FW would have to initiate the IPSec Tunnel - during your config you'd need to configure the known static peer IP address.

L0 Member

BUMP!!!

 

Anyone have success in configuring a IPsec tunnel between a Draytec Vigor and a Palo Alto?

 

Thanks.

  • 4499 Views
  • 2 replies
  • 0 Likes
Like what you see?

Show your appreciation!

Click Like if a post is helpful to you or if you just want to show your support.

Click Accept as Solution to acknowledge that the answer to your question has been provided.

The button appears next to the replies on topics you’ve started. The member who gave the solution and all future visitors to this topic will appreciate it!

These simple actions take just seconds of your time, but go a long way in showing appreciation for community members and the LIVEcommunity as a whole!

The LIVEcommunity thanks you for your participation!