Error 503: Service Unavailable

[E.Gonzalez]

Hello!

I am configuring  an ha cluster Fw 440.Firmware 10.1.3

When i push "commit" i lost gui access.

I can ping andaccessvia ssh to fw.

I recover the gui access via cli:request restart system.

I have updatefirmware to 10.1.11-h5 but i happen the same or something worst!

main fw never gotaccessvia gui

Bakcup fw happen the same than before

1.How to solve it? ideas?

2.Comamnd to enable the gui access from cli without rebooting all the fw?

Thank you

[reaper]

which changes are you committing?

if this happens frequently and you don't know why, try device > setup > operations > revert from running config

that will refresh your candidate config with what has actually been committed to the firewall, make a small change and try again

[E.Gonzalez]

Hello!

The gui access after is not working after each change i made in configuration. Forexample, just changing the name of the fw,after "commit" the gui access stop working.

How to solve it?

Thankyou

[reaper]

making changes to the management interface may cause a short restart of the management service. you may be logged out but should regain access shortly

have you tried running the 'revert running config' ?

[E.Gonzalez]

Hello! 

Yes, but i dont want to revert a change in config. 

I am sure that the change config is all right... and the problem is that the gui access stop working.

I made a change configuration.When a made "commit" gui stopped working. Via cli i restarted the fw...and i recover gui access when the fw start,and the change config is loaded.So, i think it is now because there is an error in change config.

So,i dontwant to return to previously config...i want to stop gui broken each time i push "commit".

Some ideas?

Thank you

[BenjaminIngram]

Any update?