External Palo Alto Dynamic List

[RanjithDass]

Hi Team 

Have a PA220   licensed for Wild fire, Threat prevention, and PANDB URL filtering .

Though I had configured the External Dynamic List based on the best practice, I could not get the default  PaloAlto Dynamic IP lists feed : Palo Alto Networks - High-risk IP addresses and the Known malicious IP addresses  showing up 

Could someone please guide me on how to configure the prefined Palo Alto  list  ?

Thanks

RK

[BenLassila]

Palo Alto Networks - High risk IP addresses and

Palo Alto Networks - Known malicious IP addresses

are selectable as source address or destination address in your security rules without any other prior configuration.

You can view them as Predefined in Objects > External Dynamic Lists if you wish

Hope that helps

Kind regards

[RanjithDass]

Thanks for the reply.

Those two lists are not showing up under Dynamic list. I  too thought that after syncing with the license and other updates, I should be able to see those default list under External Dynamic list but it is not.

Is it possible to create them manually?

Regards

RK

[BPry]

@RanjithDass,

I'm going to guess that you are not running 8.0.* at all? 

[RanjithDass]

Thanks Bpry for the reply .

 It is a  brand new PA220  and running on  8.0.6.

Regards

RK

[BPry]

@RanjithDass,

Well that is really weird, as it should have them included without you having to manually create them. That being said, if you do the following you should be able to create them manually.  

1) Create a new External Dynamic Lists entry and under Type, switch it to Predefined IP List. 

2) Under Source you'll have two options High risk IP addresses, and Known malicious IP addresses. 

[RanjithDass]

 Thanks again --I know  😞

My license License part

I can create new EDL list but the default ones are not showing up 

the drop down options not showing up

Not sure why the default ones were not showing up 

Regards

Rk

[BPry]

@RanjithDass,

I would contact TAC or reinstall the OS at this point. These lists should be populating perfectly fine. 

[RanjithDass]

Thanks again for the reply . 

There should be some steps on how to add it since i have tried  a factory reset and built it  from the scratch so definitely, a setup  issue somewhere 

Regards

Rk

[RanjithDass · Accepted solution]

The default list is not appearing because the PA is not having the Antivirus  installed . To get this please run the following command using the CLI.

"request url-filtering download status vendor paloaltonetworks "

Go to Devices\Dynamic Updates and do " check now "

The PA will download the Antivirus  -install the same 

Viola --- the default Dynamic IP list appears under Objects/External Dynamic List ...  🙂

Regards

Rk

[AndresAlfaro · Accepted solution]

I found this article where it specifies that for the Dynamic Lists to appear you must install the antivirus.

https://knowledgebase.paloaltonetworks.com/KCSArticleDetail?id=kA10g000000PM0pCAG