IPSEC vsys cli

[Rajab725]

Hi

I configure IPsec tunnel.
When I configure with manual on web interface, by default was adding vsys to Tunnel Interface--Virtual system.
But when i configure with cli doesn't visible vsys(it visibles empty).

which command i can used for adding vsys?

[MP18]

@Rajab725 

Do you have Multi vsys config in PA?

Regards

[Carper41]

Thanks for the information 

NJMCDirect

[Rajab725]

yes

[Rajab725]

@MP18  yes

[MP18]

@Rajab725 

Do you want to do config of tunnel interface via CLI or GUI?

Regards

[Rajab725]

As I stated above, I want to do everything with CLI.

And now i am able to :

>creating tunnel interface

>creating IKE gateway

>creating IPsec tunnel

>adding tunnel to routing.

But When I configure IPsec  on web interface, I am able to adding  vsys. It appears on the "Tunnel Interface"- - >"Virtual system tab" in "Network" - - -> "IPSec Tunnels" tab.
But when i configure with cli doesn't visible any vsys(it visibles empty). 

I have searched to this situation. as I understand it, If this section appear empty, vsys takes the default vsys value.

What I want is to be able to change vsys with CLI. I want some tunnel vsys to be vsys1, and others to vsys2.