06-11-2014 02:35 AM
Hi guys,
a customer gets a replacment of PA7050 for the PA5000 model they are currently using. Since the PA7k uses the blade slot as reference for the Interfaces my idea was to replace "ethernet1/1" from the PA5k config with "ethernet7/1" and load it up in the PA7k. Well, it didn't work as the Mgmt tells me that the reference is invalid.
A small extract from the error message is:
network -> interface -> ethernet -> ethernet7/11 ethernet7/11 is invalid. Discarding
zone -> internet -> network -> layer3 'ethernet7/11' is not a valid reference
If I instead configure a new interface and view the xml file, the interface is indeed named ethernet7/1 as the GUI tells me, so I'm quite confused what the problem is. Hopefully someone has an idea what to do as recreating the whole config from scratch would be nigh to impossible due to lots of VPN Tunnels.
Best regards
David
06-11-2014 04:13 AM
fixed it. if you have a HA1 backup via mgmt port enabled, you have to delete this entry as it doesn't work with the pa7050 and will invalidate the whole config if it isn't removed.
06-11-2014 04:13 AM
fixed it. if you have a HA1 backup via mgmt port enabled, you have to delete this entry as it doesn't work with the pa7050 and will invalidate the whole config if it isn't removed.
Click Accept as Solution to acknowledge that the answer to your question has been provided.
The button appears next to the replies on topics you’ve started. The member who gave the solution and all future visitors to this topic will appreciate it!
These simple actions take just seconds of your time, but go a long way in showing appreciation for community members and the LIVEcommunity as a whole!
The LIVEcommunity thanks you for your participation!
