NAT after Proxy

Showing results for 
Show  only  | Search instead for 
Did you mean: 

NAT after Proxy

L0 Member



I have to set up a PA-200 as a NAT.  That it self would not be the problem but between the PA-200 and the modem is a Proxy. I have no information about that proxy. The only information i have about the network is the IP settings given by DHCP. Is it somehow possible to setup the NAT with just that information and no change to the existing network?


 I would verry appreciate any help



L7 Applicator

I assume you are talking about source nat for internet access.


Then the proxy should not be an issue for applying nat because that will be a destination address for the proxyed traffic and not affect nat at all.


What you would need to know is the nat address pool range or an interface ip address that will be used for the nat on the PA.


You could assume that any source address coming in will have nat applied or if not, then you would need to know what ip address ranges to place in the nat rule to apply the source nat.

Steve Puluka BSEET - IP Architect - DQE Communications (Metro Ethernet/ISP)
ACE PanOS 6; ACE PanOS 7; ASE 3.0; PSE 7.0 Foundations & Associate in Platform; Cyber Security; Data Center
Like what you see?

Show your appreciation!

Click Like if a post is helpful to you or if you just want to show your support.

Click Accept as Solution to acknowledge that the answer to your question has been provided.

The button appears next to the replies on topics you’ve started. The member who gave the solution and all future visitors to this topic will appreciate it!

These simple actions take just seconds of your time, but go a long way in showing appreciation for community members and the LIVEcommunity as a whole!

The LIVEcommunity thanks you for your participation!