11-05-2021 02:22 PM
PBG without gateway
Good afternoon, is it possible to configure a PBF, without specifying the gateway IP address, just apply the outgoing interface and that's it? is this possible ?
I remain attentive, thank you very much.
Best regards
11-06-2021 06:34 AM
Hi @Metgatz ,
It looks like you can according to this document -> https://knowledgebase.paloaltonetworks.com/KCSArticleDetail?id=kA10g000000ClGxCAK. The only time it would work if you do not specifiy a gateway IP address is if you were forwarding the traffic to a point-to-point interface, such as a tunnel, where there is only one destination. In the doc referenced, a dummy IP address is needed on the PANW side of the tunnel.
Thanks,
Tom
Click Accept as Solution to acknowledge that the answer to your question has been provided.
The button appears next to the replies on topics you’ve started. The member who gave the solution and all future visitors to this topic will appreciate it!
These simple actions take just seconds of your time, but go a long way in showing appreciation for community members and the LIVEcommunity as a whole!
The LIVEcommunity thanks you for your participation!
