For details on cookie usage on our site, read our Privacy Policy
PPoE with Static IP Block
- LIVEcommunity
- Discussions
- General Topics
- PPoE with Static IP Block
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Printer Friendly Page
PPoE with Static IP Block
- Mark as New
- Subscribe to RSS Feed
- Permalink
12-29-2016 09:28 AM
Need to set up a small office with a PA-200 using PPoE. Simple enough...but the ISP has allocated a /29 static block (5 usable IP addresses). We currently have a few 1to1 NATs in place for an SMTP relay and web server so being able to use the entire 5 IP block is necessary. All of the instructions and tutorials pretty clearly use a single IP in PPoE setup and no discussion of a range is found. I am wondering if its possible to configure the PA-200 for PPoE with a static block and how you would go about doing that.
JB
- Mark as New
- Subscribe to RSS Feed
- Permalink
12-29-2016 10:46 AM
On the desired interface on the IPv4 tab, select PPPoE. On the Advanced tab, you can specify a static address. You should be able to include the /29 with the static address.
- GlobalProtect IPv6 findings in GlobalProtect Discussions
- Cortex Domain controllers exceptions in Cortex XDR Discussions
- Device Block List for GlobalProtect - where is it in v10.x? in GlobalProtect Discussions
- unable to add new object address to existing object address group in General Topics
- Agent Blocking files/processes dynamically based on conditions in Cortex XDR Discussions
Show your appreciation!
Click Accept as Solution to acknowledge that the answer to your question has been provided.
The button appears next to the replies on topics you’ve started. The member who gave the solution and all future visitors to this topic will appreciate it!
These simple actions take just seconds of your time, but go a long way in showing appreciation for community members and the LIVEcommunity as a whole!
The LIVEcommunity thanks you for your participation!
