06-28-2020 05:12 AM
Dear Team,
I have two interfaces configured in my panorama:
1-management interface
2 -ethernet1/1.
for software and dynamic updates by default, my traffic is going via management interface. I want to change the service route through ethernet1/1 but I am not able to see any option to change the service route. below is the snapshot.
can anyone help with this where I can find this option?
06-28-2020 08:24 AM - edited 06-28-2020 08:30 AM
You are in the right track.
You should see
Pa has role based access control.
so you need to have rights to see all the info on gui
Can you log into this PA with admin username and then try?
06-28-2020 08:32 AM
@MP18Yes, i have the super admin rights.
Is there any way to change the service route through the CLI.
06-28-2020 08:43 AM
Yes you can change it via cli.
Please use below command from config mode
# set deviceconfig system route service ??
example
set deviceconfig system route service paloalto-networks-services source address 10.0.10.1/24
where source address can be of data plane interface
06-28-2020 09:39 AM
@MP18Thank you for your reply,
I have checked this command is only working in Palo alto. when I check the same command in panorama it is not working.
Click Accept as Solution to acknowledge that the answer to your question has been provided.
The button appears next to the replies on topics you’ve started. The member who gave the solution and all future visitors to this topic will appreciate it!
These simple actions take just seconds of your time, but go a long way in showing appreciation for community members and the LIVEcommunity as a whole!
The LIVEcommunity thanks you for your participation!