08-21-2025 04:11 AM
I am moving some palo interfaces to a new cisco switch.
What is the recommended spanning tree configuration on both palo and cisco sides when connecting these devices?
PA(config-if)# spanning-tree port type ?
edge Consider the interface as edge port (enable portfast)
network Consider the interface as inter-switch link
normal Consider the interface as normal spanning tree port
should they be setup as normal on the cisco switch? and is there a setting on the palo to do the same?
08-24-2025 06:32 PM - edited 08-24-2025 06:32 PM
Hi @M.Allen ,
Can you please elaborate more on your current design?
On the Cisco side, are the switchports connected to the Palo configured as access or trunk. On the Palo, are the interfaces operating in Layer 2, Layer 3, or vWire mode?
Click Accept as Solution to acknowledge that the answer to your question has been provided.
The button appears next to the replies on topics you’ve started. The member who gave the solution and all future visitors to this topic will appreciate it!
These simple actions take just seconds of your time, but go a long way in showing appreciation for community members and the LIVEcommunity as a whole!
The LIVEcommunity thanks you for your participation!
