08-05-2018 01:12 PM
08-05-2018 01:43 PM
08-05-2018 01:57 PM
So this can depend greatly on which version of pan-os you're configuring, as some of the settings I'm about to give you haven't been need for a bit.
1) In the .vmx file verify that all ethernet"X".virtualDev values are set to vmxnet3 instead of e1000. Earlier PAN-OS images defaulted to e1000 instead of vmxnet3 adapters.
2) The virtual switch attached must be set to Accept the following; again some of this is no longer needed depending on the version.
- Promiscuous mode
- Mac address changes
- Forged trasmits (Layer2, Virtual Wire, or tap interfaces)
More than likely you're running into #1 and your vmx file isn't actually set to use vmxnet3 interfaces. Depending on the version installed you may also need to hard set MAC addresses on the interfaces; but I'm hoping your using a somewhat newer version.
08-05-2018 09:13 PM
08-06-2018 12:36 AM
08-13-2018 01:10 AM
It was found to be an issue with Vmx file entry which i have changed and fixed the issue..
Thanks for the support guys.
Click Accept as Solution to acknowledge that the answer to your question has been provided.
The button appears next to the replies on topics you’ve started. The member who gave the solution and all future visitors to this topic will appreciate it!
These simple actions take just seconds of your time, but go a long way in showing appreciation for community members and the LIVEcommunity as a whole!
The LIVEcommunity thanks you for your participation!