why is interface has no zone configuration？

[sobigfat]

Configure the following alarms
The interface also cannot ping

Where is the configuration problem?

[BPry]

@sobigfat,

Validate what the configuration is showing in the CLI, and if it matches the GUI try running the validate within the CLI instead of the GUI. 

[reaper]

see if something odd shows up in config audit, then try a 'revert to running'

[sobigfat]

@BPry

Configuration I have committed, but there is still no regional configuration in the CLI.

I reset the device, it will work normally after reconfiguring according to the original configuration, and the CLI can also see the area information.

[sobigfat]

@reaper

Very strange, the device is reset, there is no other configuration, I have no way, the configuration can work normally after resetting the device again.