01-29-2019 06:59 PM
Configure the following alarms
The interface also cannot ping
Where is the configuration problem?
01-29-2019 08:04 PM
Validate what the configuration is showing in the CLI, and if it matches the GUI try running the validate within the CLI instead of the GUI.
01-30-2019 06:41 AM
see if something odd shows up in config audit, then try a 'revert to running'
01-30-2019 10:46 PM
Configuration I have committed, but there is still no regional configuration in the CLI.
I reset the device, it will work normally after reconfiguring according to the original configuration, and the CLI can also see the area information.
01-30-2019 10:49 PM
Very strange, the device is reset, there is no other configuration, I have no way, the configuration can work normally after resetting the device again.
Click Accept as Solution to acknowledge that the answer to your question has been provided.
The button appears next to the replies on topics you’ve started. The member who gave the solution and all future visitors to this topic will appreciate it!
These simple actions take just seconds of your time, but go a long way in showing appreciation for community members and the LIVEcommunity as a whole!
The LIVEcommunity thanks you for your participation!