GlobalProtect intrazone access

[EmilySamolewicz]

Is it possible to create a rule to allow certain intrazone traffic for GlobalProtect clients. E.g. so that client1 on GP can ping client2s GP interface. I tried creating a specific rule that would allow traffic from GlobalProtect security zone to GlobalProtect security zone but no luck. Is this type of functionality achievable with GlobalProtect?

[upelister]

Hello,

If there is an clean up rule before default rules, which allows intrazone traffic. There shoud be a specific rule above cleanup rule in oreder to allow ping, icmp and trace route. You can try this allowing gp-zone to gp-zone; source as any and destination as any, service as application default and application any (to monitor what happens).

Also check the windows firewall if windows firewall is on, host machines not reply ping request. 

[EmilySamolewicz]

Hi, I have tried this without success with the configuration show in the attached image. The source and destination address are the GlobalProtect subnet 10.10.1.0/24 which I can't imagine is a problem. Windows firewall is also set to allow this traffic.

[Mick_Ball]

This is showing policy 17. The count is zero. Do you have a policy before this that is denying gp    Traffic.

[EmilySamolewicz]

No setting denying anything from the GP zone in this list of policies except default rule found at the end which is for interzone.

[Mick_Ball]

ok so override the two default policies and log session start, don't bother forwarding logs.

then on the firewall you will see what is happening to the pings.