cli error messages during boot

[lostdragon]

Dear community,

after factory resetting one of our pa220s i am seeing multiple error messages during boot up

Starting ntpd: [  OK  ]

FATAL: Module nfsd not found.
FATAL: Error running install command for nfsd
Starting NFS services:  [  OK  ]

Starting NFS mountd: [  OK  ]

Starting NFS daemon: [  OK  ]

Starting RPC idmapd: [FAILED]

Starting PAN Software: cp: cannot stat '/opt/pancfg/mgmt/wf_backup/wildfire-images/*': No such file or directory
cp: cannot stat '/opt/pancfg/mgmt/wf_backup/curwildfire/*': No such file or directory
cpld: module license 'Proprietary' taints kernel.
Disabling lock debugging due to kernel taint
cgroup: cgroups_setup (2895) created nested cgroup for controller "blkio" which has incomplete hierarchy support. Nested cgroups may change behavior in the future.
[  OK  ]

The device comes up with a green status LED, but since it is to be deployed in a far away remote location i am wondering if it is best to open a support call?

Thank you in advance for your help.

[reaper]

try loading it with appropriate licences and downloading and installing latest content packages, this may clear up the errors

[lostdragon]

@reaperThank you for your response. The device is now fully licensed and updated to PAN-OS 9.0.2 with the latest content updates.

But unfortunately some errors remain

Starting ntpd: [  OK  ]

FATAL: Module nfsd not found.
FATAL: Error running install command for nfsd
Starting NFS services:  [  OK  ]

Starting NFS mountd: [  OK  ]

Starting NFS daemon: [  OK  ]

Starting RPC idmapd: [FAILED]

Starting PAN Software: cpld: module license 'Proprietary' taints kernel.
Disabling lock debugging due to kernel taint
cgroup: cgroups_setup (2830) created nested cgroup for controller "blkio" which has incomplete hierarchy support. Nested cgroups may change behavior in the future.
[  OK  ]  

[MP18]

did you open tach case for this?

or lets see if anyone replies to this curious to know about this?

[MarTe]

I have the same errors just after upgrading PA-820 (out of the box- default config) from 8.1.6 to 9.0.4.

[thierman]

Did anyone get a resolution to this?  I’m seeing the same thing. Only noticed today after my pa220 crashed. And I connect up the serial port to observe the reboot. 

[reaper]

May want to try factory reset to fix this issue

[MarTe]

I was able to restore the system formatting all partition, did disk check for all partition and reinstall PAN-OS. I think that CLI error is an OS bug.

[MP18]

Seems still error is there?

[HemantThorve]

Hi,

I have seen this message during reboot of almost all models and Pan-OS and thinking this is normal behavior. Once firewall boots up observed no issue.