HA Link Monitoring.

cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
Announcements
Please sign in to see details of an important advisory in our Customer Advisories area.

HA Link Monitoring.

L2 Linker

Is there any pre-requisite to keep the interface speed and duplex to auto , auto if we are using them in HA Link Monitoring?

During our HA Test our PA interfaces are kept in duplex auto , speed 1000 setting , we have shutdown the switch interface , PA has detected that that interface is down ( forced down) but it's not triggering the failover , when we set the speed to auto ..it has triggered the failover.

1 accepted solution

Accepted Solutions

Cyber Elite
Cyber Elite

Hello,

Might want to reach out to support to see if they have anything.

Regards,

View solution in original post

3 REPLIES 3

Cyber Elite
Cyber Elite

Hello,

Not sure if its a requirement, however I recommend to keep it auto/auto unless there is a dire need not to (i.e. an ISP link that is hard set).

Regards,

L2 Linker

Thank you for your kind response, it would be nice if I can find an official document. I have researched a bit but nowhere does it mentions about speed and duplex settings.

 

Cyber Elite
Cyber Elite

Hello,

Might want to reach out to support to see if they have anything.

Regards,

  • 1 accepted solution
  • 1660 Views
  • 3 replies
  • 0 Likes
Like what you see?

Show your appreciation!

Click Like if a post is helpful to you or if you just want to show your support.

Click Accept as Solution to acknowledge that the answer to your question has been provided.

The button appears next to the replies on topics you’ve started. The member who gave the solution and all future visitors to this topic will appreciate it!

These simple actions take just seconds of your time, but go a long way in showing appreciation for community members and the LIVEcommunity as a whole!

The LIVEcommunity thanks you for your participation!