10-19-2022 02:52 AM
Hello
When I am configuring sub-interface (or interface) with CLI from Panorama as :
set template [name] config network interface ethernet ethernet1/x layer3 interface-management-profile [Profile] units ethernet1/x.x comment [comment] tag [xx] ip [xx.xx.xx.xx/xx]
All is working fine excepting the management profile that is not taken in account and need to add it with GUI.
Any idea about it ?
Regards
10-21-2022 12:25 AM - edited 10-21-2022 12:50 AM
Yes.
As I wrote, I have to do it with GUI to be taken in account.
I just discovered i can do it in second step by adding :
set template [name] config network interface ethernet ethernet1/x layer3 units ethernet1/x.xx interface-management-profile [profile]
Maybe the position of the setting in the full request is not good.
Regards
10-19-2022 05:41 PM
Hi @didier.bonato ,
Do you have the management profile created and committed already?
10-21-2022 12:25 AM - edited 10-21-2022 12:50 AM
Yes.
As I wrote, I have to do it with GUI to be taken in account.
I just discovered i can do it in second step by adding :
set template [name] config network interface ethernet ethernet1/x layer3 units ethernet1/x.xx interface-management-profile [profile]
Maybe the position of the setting in the full request is not good.
Regards
Click Accept as Solution to acknowledge that the answer to your question has been provided.
The button appears next to the replies on topics you’ve started. The member who gave the solution and all future visitors to this topic will appreciate it!
These simple actions take just seconds of your time, but go a long way in showing appreciation for community members and the LIVEcommunity as a whole!
The LIVEcommunity thanks you for your participation!
