- Access exclusive content
- Connect with peers
- Share your expertise
- Find support resources
04-01-2020 01:47 AM
We have several IPSec tunnels that connect to 4G devices to provide network access in the event of a primary circuit outage. These tunnels do not disconnect after the primary circuit comes back up. Is there a way on the PAN side to disconnect an IPSec tunnel if there has been no traffic on it in a given amount of time?
we are using IKE V1 and static route
04-02-2020 08:58 AM
Hi @snimshad ,
Have you set up some PBF failover ?
Can you add some more details on your config ?
-Kiwi.
04-08-2020 03:13 AM
there is no pbf failover set up as of now...tunnel monitoring is in place to monitor the liveness of peer.
04-09-2020 02:34 PM
Hello,
Tunnel monitoring send pings across the tunnel. This is why it is always active. What I have done in the past is setup a PBF policy to use the main connection first and then the tunnel second.
Hope that helps.
Click Accept as Solution to acknowledge that the answer to your question has been provided.
The button appears next to the replies on topics you’ve started. The member who gave the solution and all future visitors to this topic will appreciate it!
These simple actions take just seconds of your time, but go a long way in showing appreciation for community members and the LIVEcommunity as a whole!
The LIVEcommunity thanks you for your participation!