i have the problem that I have two PA-445 as HA clusters where the management interface does not have an uplink.
I've already tried several cables and switches, but unfortunately I can't get an uplink on the interface.
There is no spanning tree on the switches, all ports are active.
Type: 1000T, Mode Auto, Flow disabled.
Switch port: VLAN 112, mode access
From the PA:
Name: Management Interface
Runtime link speed/duplex/state: unknown/unknown/down
Configured link speed/duplex/state: auto/auto/auto
Is there anything special about a cluster that needs to be done in order to get both management interfaces running?
Hi @Frank_Liebelt ,
Can you try connecting your laptop/desktop directly to each one of the PA-445s and test connectivity to the GUI from your computer?
If you are able to connect then there is likely an issue with physical layer, speed/duplex, or vlan config.
I would that the link speed and duplex settings on both the firewall's management interface and the switch port are set to auto. Then I would verify that VLAN 112 is correctly configured on your network. Do you currently have devices connected to VLAN 112 that are connected and can get out to the internet? I would cross-check with other devices in that VLAN.
Click Accept as Solution to acknowledge that the answer to your question has been provided.
The button appears next to the replies on topics you’ve started. The member who gave the solution and all future visitors to this topic will appreciate it!
These simple actions take just seconds of your time, but go a long way in showing appreciation for community members and the LIVEcommunity as a whole!
The LIVEcommunity thanks you for your participation!