12-16-2016 08:34 AM
Hopefully this is a very simple question, but I wanted to make sure I was actually researching the correct thing.
I am planning on connecting a hypervisor (Hyper-V 2012), directly to one of my Network Interfaces on my PA. The hypervisor has multiple VLANs, and I need them all to go through the PA. I incorrectly thought if I just set the VLAN/Virtual Wire to "none" that it would just allow through whichever VLAN that the hypervisor tagged the traffic as. Am I now correct in thinking that I need to create a Virtual Router that takes in both VLANs? Can anyone point me to some instructions on how to set this up correctly?
12-16-2016 08:43 AM - edited 12-16-2016 09:17 AM
Hi,
So my understanding is that you will have a multiple VMs running on the Hyper-V server on the different VLANs. What you could do is to have a subinterfaces configured on the PA physical interface. VR it is just a routing table attached to the interface.
Check this out:
Thx,
Myky
12-16-2016 08:43 AM - edited 12-16-2016 09:17 AM
Hi,
So my understanding is that you will have a multiple VMs running on the Hyper-V server on the different VLANs. What you could do is to have a subinterfaces configured on the PA physical interface. VR it is just a routing table attached to the interface.
Check this out:
Thx,
Myky
Click Accept as Solution to acknowledge that the answer to your question has been provided.
The button appears next to the replies on topics you’ve started. The member who gave the solution and all future visitors to this topic will appreciate it!
These simple actions take just seconds of your time, but go a long way in showing appreciation for community members and the LIVEcommunity as a whole!
The LIVEcommunity thanks you for your participation!
