10-26-2023 08:13 AM
I have setup my VM on a single desktop with 4 NICS to connect to different subnets and security zones and to have different interface setups for the VM. Two other desktops have NICS with different subnet scopes. I have created a rule to test ping traffic from zone 'A' to zone 'B' as an example. You can ping from a client in zone 'A' to a client in zone 'B' but there is no Hit Count seen and no traffic logs either. I have tried recently to separate the subnets using a simple routing protocol RIP v2, on Cisco Routers but I have encountered the same problem as described above. Any hints on why my rules are not being hit would be welcome. Note though that the hit count for the intrazone and interzone default rules do increment and are the only rules that seem to work.
10-31-2023 08:36 PM
Hi @Radcliffe_Barham ,
Does the security policy hit count still show 0 hits? Can you also verify you have a log setting checked on the Actions tab within the security policy?
11-01-2023 12:54 PM
Hit count still shows 0 and log settings are checked on my actions tab.
11-02-2023 03:10 PM
Are we talking about a licensed VM or an unlicensed one? Your behavior would be expected from an unlicensed VM
11-02-2023 03:29 PM
This is a licensed VM or to be clear a full eval VM 50. All software licenses are active.
Click Accept as Solution to acknowledge that the answer to your question has been provided.
The button appears next to the replies on topics you’ve started. The member who gave the solution and all future visitors to this topic will appreciate it!
These simple actions take just seconds of your time, but go a long way in showing appreciation for community members and the LIVEcommunity as a whole!
The LIVEcommunity thanks you for your participation!
