06-19-2012 06:36 AM
I would like to be able to reach the web management interface and the CLI of our PA device, while connected through the Global Protect VPN. The networks are on separate segments, and I have access routes and rules in place to allow the traffic to the management IP. However no luck with reaching it. Any advice/help would be appreciated.
06-19-2012 07:11 AM
Have you configured a management profile and attached that to the interface/zone which is used when you come through the VPN?
06-19-2012 07:11 AM
Have you configured a management profile and attached that to the interface/zone which is used when you come through the VPN?
06-19-2012 08:01 AM
I do have a management profile that is attached to the interface, that allows https, ssh, and still unable to reach the management address.
06-19-2012 11:08 AM
Do you have a separate zone for the VPN? If so is there a rule allowing traffic from the VPN zone to the management IP?
06-19-2012 11:10 AM
You could also create a loopback address and create a route and a policy to that address for management.
06-21-2012 02:09 PM
The management profile needed to be attached to not the zone that the VPN traffic came in through so in our case Eth1/1 (Internet) but the interface that the VPN put the users Eth2/2 (trusted).
Thanks for the help.
Click Accept as Solution to acknowledge that the answer to your question has been provided.
The button appears next to the replies on topics you’ve started. The member who gave the solution and all future visitors to this topic will appreciate it!
These simple actions take just seconds of your time, but go a long way in showing appreciation for community members and the LIVEcommunity as a whole!
The LIVEcommunity thanks you for your participation!
