Reset PA-200 to default settings

[sstasiukonis]

I can't seem to find the control for resetting the PA-200 to the original out of the box config.  Any assitance is appreciated.

Thanks

[jseals]

Hello,

In order to reset to factory defaults, you'll need to console directly to the PAN device through its console port.

Then, you'll need to reboot the machine. During boot, hit the letter "m". Then if asked, type "maint".

This should enter you into maintenance mode, and from there you can reset to factory defaults.

Let us know if you have any issues.

Thanks,

Jason Seals

[jseals · Accepted solution]

Also,

Here is a document with screenshots that goes over the process:

https://live.paloaltonetworks.com/docs/DOC-4692

Thanks,

Jason Seals

[sstasiukonis]

Jason:

Thank you, do you have something already made up for stepping me through a layer 3 install. The quick start is OK, but something more descript would be better.

Thanks,

Steve

[jseals]

Steve,

Here is a video that goes through a basic L3 deployment.

https://live.paloaltonetworks.com/videos/1014

Otherwise, the Administrators guide is also a good resource.

Thanks,

Jason Seals

[sstasiukonis]

This is great!!! Thank you.

Steve

[jseals]

Great Steve!

If you could please mark the discussion as answered that would be helpful for us.

Also, if you run into any trouble, feel free to open a case or another discussion post.

Thanks and goodluck with your deployment,

Jason Seals

[sstasiukonis]

Just did it. Thanks again.

Steve

[jseals]

Great Thanks!

If you have any trouble, let us know.

Thanks,

Jason