04-26-2020 01:49 PM
Hi,
I configure my device to virtualwire mode with sfp baseT transceiver but it wan't to work (they are red in GUI).
When I change to Layer3 mode everything work corectly (change to green).
In CLI I can see transceiver.
Have you got similar problem or any advice what should I do?
04-28-2020 12:23 PM
Hello,
Are the connections up and running on both sides of the virtual-wire? It will show down if one of the endpoints is not up.
Regards,
04-28-2020 10:56 PM
Before I change it works fine.
From one side is switch and other is router.
It's work on built in ports but not on sfp.
04-29-2020 07:19 AM
Hello,
Perhaps take a step back and go through the setup again to make sure nothing was missed? Ports are in the proper zone, added to a v-wire config, policies, etc.
Regards,
04-30-2020 01:38 PM
First think I've done was make virtualwire zone and interface. Policy was simple any to any in both side.
I'll try one more time maybe I missed something simple.
Click Accept as Solution to acknowledge that the answer to your question has been provided.
The button appears next to the replies on topics you’ve started. The member who gave the solution and all future visitors to this topic will appreciate it!
These simple actions take just seconds of your time, but go a long way in showing appreciation for community members and the LIVEcommunity as a whole!
The LIVEcommunity thanks you for your participation!
