How to reset DR using Remote Control Client?

cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
Announcements

Welcome Idira to LIVEcommunity!

Our community just got stronger! Explore new identity security resources, connect with experts, and discover more ways to learn and collaborate.

Meet Idira

PAM Self-Hosted Articles
2 min read
L0 Member
No ratings
How do I reset the DR back to normal state (Disaster Recovery service is running and Vault server service is stopped) using the Remote Control Client? Q:
How do I reset the DR back to normal state (Disaster Recovery service is running and Vault server service is stopped) using the Remote Control Client?

A:
To reset the DR back to normal state make sure the Production Vault is up and follow the steps below:
  1. Connect to the DR Vault using the Remote Control Client:
  2. > PARClient <DR Vault DNS name or IP>
  3. Stop the Vault server service on the DR Vault:
    PARCLIENT> stop vault
    Are you sure you want to stop the remote Vault (Y/N)? Y
    Password: *********
    Vault was stopped successfully
  4. Set the 'FailoverMode' parameter in the PADR.ini file on the DR Vault to "No":
    PARCLIENT> setparm padr failovermode=no /permanent
    Password: *********
    Parameter failovermode has been successfully updated for component PADR
  5. Start the Disaster Recovery service on the DR Vault:
    PARCLIENT> start padr
    Password: *********
    PADR was started successfully

Use the following command To check the disaster recovery logs:
PARCLIENT> getlog padr /TIMEFROM <DDMMYYYY:HHMM>
Password: *********

Look for the following message to verify that the replication ended successfully:
PADR0010I Replicate ended.

Note: The first replication will fail with an error. This is expected but the DR service will recover from this error and will complete a successful replication the next time it runs
Rate this article:
  • 829 Views
  • 0 comments
  • 0 Likes
Article Dashboard
Version history
Last Updated:
‎05-29-2023 05:49 PM
Updated by: