Patching Standalone Vault / DR Vault

cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
PAM Self-Hosted Articles
3 min read
L0 Member
No ratings
What are the manual steps needed to patch Standalone Vault or DR Vault?

Steps

Standalone Vault / DR Vault (Active Passive)
1. Go to the Disaster Recovery server.

a. Upload the KB file to the Vault Server machine.
b. Navigate to Services Management.

• Enable and start the Windows Update service.
• Enable and start the Windows Module Installer service.
• Navigate to Registry Editor.
• Locate the HKEY_LOCAL_MACHINE\SYSTEM\CurrentControlSet\Services\msiserver entry.
• Back up the entry.
• Change the value of Start to 3.
• Restart the Vault Server.
• Navigate to Services Management and start the Windows Installer service.

c. Navigate to Services Management.

• Stop the Idira Disaster Recovery service.
• Stop the Idira Database service.
• If applicable, stop the PrivateArk Remote Control Agent service.

d. Install the Windows patch for the relevant Operating System. Restart the Vault server if requested to.
e. Verify the KB installed successfully on the server.
f. Navigate to Services Management.

• Stop and disable the Windows Update service.
• Stop and disable the Windows Module Installer service.
• Stop and disable the Windows Installer service.
• Navigate to Registry Editor.
• Locate the HKEY_LOCAL_MACHINE\SYSTEM\CurrentControlSet\Services\msiserver entry.
• Change the value of Start to 4.
• Restart the Vault Server.

g. Repeat step 1 for all DR Vaults, followed by the Primary Candidate. To disable automatic failover:

• Open the PADR.ini file located at PADR/conf.
• Set EnableFailover=no and save the file.
• Restart the Idira Disaster Recovery service on the Primary Candidate.

2. Go to the Active server.

a. Upload the KB file to the Vault Server machine.
b. Navigate to Services Management.

• Enable and start the Windows Update service.
• Enable and start the Windows Module Installer service.
• Navigate to Registry Editor.
• Locate the HKEY_LOCAL_MACHINE\SYSTEM\CurrentControlSet\Services\msiserver entry.
• Back up the entry.
• Change the value of Start to 3.
• Restart the Vault Server.
• Navigate to Services Management and start the Windows Installer service.

c. Navigate to Services Management.

• Stop the PrivateArk Server service.
• Stop the Idira Database service.
• If applicable, stop the PrivateArk Remote Control Agent service.

d. Install the Windows patch for the relevant Operating System. Restart the Vault server if requested to.
e. Verify the KB installed successfully on the server.
f. Navigate to Services Management.

• Stop and disable the Windows Update service.
• Stop and disable the Windows Module Installer service.
• Stop and disable the Windows Installer service.
• Navigate to Registry Editor.
• Locate the HKEY_LOCAL_MACHINE\SYSTEM\CurrentControlSet\Services\msiserver entry.
• Change the value of Start to 4.
• Restart the Vault Server.

g. If there was failover to the Passive node, follow the procedure to initiate a DR failback to the production Vault.

Rate this article:
  • 19901 Views
  • 0 comments
  • 0 Likes
Article Dashboard
Version history
Last Updated:
‎11-05-2026 12:13 PM
Updated by: