Patching Clustered Vaults or Distributed Clustered Vaults

cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
Announcements
Scheduled Maintenance: November 14–15 (starting Nov. 14 at 12:00 AM PST)
LIVEcommunity will temporarily operate in read-only mode as we prepare to welcome Idira!
Public content will remain accessible, but log-ins, posting and community interactions will be paused during this period. Thank you for your patience!
PAM Self-Hosted Articles
2 min read
L0 Member
No ratings
What are the needed steps to patch Clustered Vaults or Distributed Clustered Vaults?

Steps

Cluster Vault / Disaster Recovery Cluster Vault / Disaster Recovery MS Cluster Vault / Cluster within Distributed Vaults

Notes:

• For Disaster Recovery Clustered Vault, start with the DR site.

• For a Cluster within Distributed Vaults, start with the Satellite site.

On the Disaster Recovery / Satellite site:
1. Connect to the passive node.

a. Upload the KB file to the Vault Server machine.
b. Navigate to Services Management.

• Enable and start the Windows Update service.
• Enable and start the Windows Module Installer service.
• Navigate to Registry Editor.
• Locate the HKEY_LOCAL_MACHINE\SYSTEM\CurrentControlSet\Services\msiserver entry.
• Back up the entry.
• Change the value of Start to 3.
• Restart the Vault Server.
• Navigate to Services Management and start the Windows Installer service.

c. Stop the passive node from the Idira Cluster Vault Management interface and exit the application.
d. Install the Windows patch for the relevant Operating System. Restart the Vault server if requested to.
e. Verify the KB installed successfully on the server.
f. Navigate to Services Management.

• Stop and disable the Windows Update service.
• Stop and disable the Windows Module Installer service.
• Stop and disable the Windows Installer service.
• Navigate to Registry Editor.
• Locate the HKEY_LOCAL_MACHINE\SYSTEM\CurrentControlSet\Services\msiserver entry.
• Change the value of Start to 4.
• Restart the Vault Server.

2. Connect to the active node.

• Initiate failover (switch-over) to the passive node on the same site, wait for the failover to complete.
• Follow step 1.

3. Repeat steps 1-2 on all Disaster Recovery / Satellites sites.
4. Repeat steps 1-2 on the Primary site.

Rate this article:
  • 4206 Views
  • 0 comments
  • 0 Likes
Article Dashboard
Version history
Last Updated:
‎11-05-2026 12:13 PM
Updated by: