Fixing Crypto IPSec and IKE Gateways for Tunnels- Missing?

[keikenberry]

I am working on a new project with an ASA config I have used in a previous project.  I am attempting to clean up the IPSec Tunnels as it's saying I need to apply new crypto profile to the outside map.  However, I do not see where it shows the existing crypto profiles anymore.  Is anyone else experiencing this issue?  

[lychiang]

Hello @keikenberry 

Please review configuration under Network-> VPN section as attached screenshot, most likely you need to re-attache the IKE crypto profile to the IKE gateway and review the IPsec crypto profile of each VPN tunnel. 

 

[keikenberry]

Thank you @lychiang .  That is the tab I am looking for, but for some reason it's no longer there.  Any suggestions?  

[lychiang]

On the left side panel of the screen you show me , there are two tabs, you are currently in the first tab- IPsec Tunnel tab, switch to 2nd tab- "Network Profile" tab , you will see all IKE crypto , IKE gateway, IPsec Crypto configuration, etc there. 

[keikenberry]

The tabs are not on the left side of the panel.  This is why I am perplexed, because it was there a couple of days ago, but now it's not.    

[keikenberry]

[lychiang · Accepted solution]

The tab looks like below screenshot.  If it was there few days ago but it is not, I would suggest you restart your Expedition VM and close all your browser and re-launch the GUI, try different browser as well.  

 

[keikenberry · Accepted solution]

I restarted the VM and my tabs are back.  Thanks!