03-16-2012 12:16 PM
I think I may have found a bug with PANOS 4.1.1 on PA-5050s where the WebUI will not display new signatures until the user has logged out and logged back in again.
I left a browser (Firefox 10) logged in for several days, using it just enough that the session did not time out. During this long session, a content update was installed. However, when I went looking for the new signatures, I could not find them. They would not appear in the new Vulnerability Profile or new Spyware Profile dialogs, even if I searched by the CVE number or the Vendor ID.
A new session in a new browser showed them, so I tried logging out of the old session and logging in to a new one. The signatures were now available in the dialogs.
This is obviously a little tricky to reproduce since there's only a content update once a week. I will try to do it again next week though.
Has anyone else seen this behaviour?
03-28-2012 02:41 PM
Hello
I have looked over our bug database and knowledge piont found no similar reported issue.
If you can upgrade to PANos 4.1.3 and see if this fixes this or please open up a case with support so we can assist in investigating this.
Thank you
Al
03-30-2012 05:21 AM
Hi Al,
We've actually recently upgraded to 4.1.4. I'm not able to confirm if the problem still exists because my sessions will not stay logged in long enough. I just posted in another thread that idle timeout = 0 does not work.
Click Accept as Solution to acknowledge that the answer to your question has been provided.
The button appears next to the replies on topics you’ve started. The member who gave the solution and all future visitors to this topic will appreciate it!
These simple actions take just seconds of your time, but go a long way in showing appreciation for community members and the LIVEcommunity as a whole!
The LIVEcommunity thanks you for your participation!
