Panorama - Force Template Value Option

Hello good evening:

As always, thank you very much for the support, collaboration, support and help.

I have the following important question regarding a PANORAMA function, in relation to the "Forced Template Values" option.
According to the document

Panorama 10.1.6 wants to push keys and secret every time

Hi all,

I want to upgrade my Panorama, 220s and 3220s from 10.0.10 to 10.1.6.

I started upgrading Panorama and a 3220 HA Active Passive Pair to 10.1.6

No issues during update.

When I want to push config to devices, I notice that the 3220s are shown "

Panorama Template Push to Firewall always fails, unless you push Device Group at the same time

Panorama - VM ESXi - Panorama mode - version 10.1.4

When Panorama Template Push to Firewall always this always fails, reports out of sync and when you log directly to the firewall you do not see the changes.

When you push Device Group and the Tem

Add Shared Gateway FW into Panorama

I am trying to add a stand alone fw into Panorama, v 10.0.8. After I add the device in Pan and commit , the device shows as connected. I then import the config which includes a shared gateway. When I commit the config in Pan I receive an error messag

Panorama template section is empty : No interfaces, no zones

Hello team,

 I have 2 firewalls managed in my panorama.

When I go to template section on Panorama I can not see anything, any interfaces, zones so it's not possible to make any change from the Panorama. 

I have to make changes directely on the firewa

Is it possible to exclude a particular IP from forwarding logs to the syslog server, that too particularly deny logs for that IP

Bulk add existing addresses to an existing group

Hello,

I'm hoping someone can help out.  I've just finished a merge from an ASA to Palo Alto through Expedition.  The ASA had 3000+ addresses as part of an existing address group.  I've tried multiple times to merge, and push the changes through the A

Postponing Logdb Migration

I have a Legacy mode Panorama virtual appliance running PANOS 8.1 that I am planning on upgrading to 10.2. Would the below order of operations be a valid approach or does logdb migration NEED to occur before performing PANOS upgrades?

1. Perform Pa

Shared RADIUS Server Profile, and Shared Authentication profile not showing up in a new Template?

Hi Friends,

Please note that I have a Panorama running version 10.1.5-h1, and I just registered a couple of new PA-440 Palos which have the same software version 10.1.5-h1.

I also provisioned it's corresponding Template Stack, Device Group, and pushe

Panorama log disk migration error - 10.1.5-h2

Hi All,

We want to move Panorama's log disk from a passthrough iSCSI disk to a local VHDX (Hyper-V). We've tried cloning the volume, but Panorama wipes the data because it initializes the disk. If we try to start the log migration from the CLI we g

upgrade consideration for collector group in 10.1

We want to upgrade panorama from 10.0 to 10.1. We have HA panorama M200 , in Collector group we have three LCs (Primary Panorama Local LC , Secondary Panorama Local LC , Dedicated LC )

Below upgrade consideration point applicable for above setup ?