I have a customer who is trying to configure MFA in GP with RSA SecureID server with Radius server profile (Not the MFA profile that was introduced with 8.1).
The first factor should be user name and password and the second factor should be an OTP token.
Both username, passowrd and token should be validated by the RSA server.
I have done the configuration by following the below KB
Now when i try to authenticate GP shows only the first step (Password), and it does not prompt for the OTP.
So i need to know if there is a configuration on GP to enable the OTP popup?
Also if am using an email/SMS token, the firewall should send a request first in order for the token to be generated, is there is a way to configure this method in PA?
also is there is a behavior change between 8.0 and 8.1 in the way GP handles MFA with Radius server profile?
I think you are getting confused, the KB listed is 2 factor auth, not multi factor.
so what is happening is you are logging into the portal with user and password, the portal then generates a cookie to auth you to the gateway.
if you need multi factor without using MFA, the best you can do is have seperate auth servers on portal and gateways but unfortunately you are using same radius for both passcode and password...
does that make sense?
What you are asking for is possible. The problem here that GP does not ask for OTP isn't located on the firewall - it is a problem on your RSA server. When your RSA Radius server receives username and password (if the credentials are valid) it needs to reply with an Access-Challenge packet. This way GP would show the OTP prompt. Right now your RADIUS server sends back directly an access-accept packet so the firewall and GP see only a valid authentication without the need to ask for OTP.
Have you looked at the Authentication profiles and sequencing?
Might be worth a look. Also support is always around to help out if you need a resolution quicker.
I've heard that Palos don't do auth sequences like you would like them to in this specific situation.....it will check for a successful authentication and when it takes, it stops.....it doesn't necessarily go through each one, every time....which is what we are looking for here i believe.
Click Accept as Solution to acknowledge that the answer to your question has been provided.
The button appears next to the replies on topics you’ve started. The member who gave the solution and all future visitors to this topic will appreciate it!
These simple actions take just seconds of your time, but go a long way in showing appreciation for community members and the LIVEcommunity as a whole!
The LIVEcommunity thanks you for your participation!