05-08-2024 06:48 AM
Hi All,
so we are in the process of deploying a few brand new PA 1410's out the box.
during initial bootup the field engineer connects with the console cable, and is then asked to install either ZTP mode or standard mode.
engineer selects standard mode and proceed.. all good.
once mgmt IP is configured i can then connect remotely and do the config.
however, i noticed that there are ztp based config auto configured.. the palo (pan-os 11.0.0 out the box) installs a loopback.900 interface with a 100.64.x.x ip and a ztp vr route
the service route is also set to custom and i cannot set it to default. i have to change the custom routes individually to default else it tries to talk from the loopback interface.
i checked also in the cli using 'show system ztp status' and it is showing as being disabled.
is it normal that it adds some ztp config into the base config or is it maybe a bit buggy?
so now i have to try and work around the ztp config and override the settings to make changes. bit of a headache.
any ideas?
have included some screenshots fyi
thanks in adv
