Panorama - SDWAN Autogenerated Config Nightmare

I have spent the better part of two days deploying what should be a simple, standard SDWAN solution following the provided documentation. No matter how many times I try, every time I get to the point where I create the VPN Cluster, I get commit failu

Server error : Failed to add authkey. Failed to update DB.

Trying to simply generate an authkey in Pano so as to add devices.  Getting the message:
Server error : Failed to add authkey. Failed to update DB.

Sometimes it says I'm already "using that name" but there are zero valid authkeys present.

Any sugges

Panorama Device Specific Templates Network Settings

In our Panorama exists a Standard Template.  In the standard template I define ethernet1/5 with several sub interfaces.  At one of our locations I need to add a sub interface for vlan 88.  To tackle this, I have a device specific template that is in

Panorama support Azure site recovery service

Hi,

I have deployed single Panorama in Primary region only  to manage VM-series firewall deployed in Primary and secondary region.

I have a requirement that Whenever my Primary region goes down Panorama moves from Primary region to secondary region

Downgrading from 11.1.2-h3 to 10.2.0.h3

I know downgrading is not recommended but for a configuration management requirement I may have to downgrade from 11.1.2-h3 to 10.2.0-h3. On a test bench unit I upgraded it up to 11.1.2-h3, and following the downgrade procedure I downgraded to 10.2 

Query RE: Access Domains

Hi Team,

I have a requirement as a user wanted to give full access to a Device Group A and Just a read only access only for monitor to a Device Group B. Will this be possible in Panorama using Access Domain or any other method ?

Panorama 

m500 to m700 migration

Has any attempted to migrate from an M500 Panorama to an M700? Palo support documents seem to indicate that there is a gap in support between the two hardware models. M500 final code release 10.1 and M700 initial code release 10.2.

matrix link Pa

Panorama and managed devices secure comunication

Hello everyone, can someone help me figure out, how is secure communication built between managed firewalls and Panorama. The issue is that one of the firewalls lost connection, it was an ssl eror, I went by procedure recommended by panw to re-establ

Local Log collector Runtime Status showing "Disconnected"

Hi Mates,

I want to know why Runtime status is disconnected.

Error - Log collector XXXX failed to connect to XXXXX-inter-lc in the ring

We are using Panorama as a "panorama" and "log-collectors"

Setup is " Active/Passive.

Issue : Managed Log coll

The override stack template is not working

Hi,

I want to change the syslog profile on stack template zone with override.
When i try to change log setting for None and click "Ok". The override not working the log setting not change.
do you know why?

Can you help me please?

Created date mismatch in Rules for Device Group

Hi Team, 

I have got a chance to verify a security rule base today, I am seeing two different created date for a two firewalls in the same device group. 

Does anyone have noticed this behavior before, If yes why this mismatch. 

ike sa for gateway id not found

Hi Team,

When we test the vpn and run the show vpn ike-sa ommand below, we see ID not found, is that mean there is config issue on palo side (other end is cisco) or is it becuase no traffic from peer.

I am able to ping to peer ip but dont see any tra