For details on cookie usage on our site, read our Privacy Policy
OSPF Route Filtering / Suppression
- LIVEcommunity
- Discussions
- General Topics
- OSPF Route Filtering / Suppression
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Printer Friendly Page
OSPF Route Filtering / Suppression
- Mark as New
- Subscribe to RSS Feed
- Permalink
03-24-2015 05:49 PM
Hey guys, I have a couple questions about OSPF on the PAN. I am running code 6.0.9 and have a recent request to bring up a new OSPF area for a special project. Right now we have OSPF area 0.0.0.0 and everything works great, we haven't had the need for any additional areas until now.
I would like to bring up area 0.0.0.1 and only advertise a couple routes from area 0.0.0.0, for example 10.100.0.0/16, likewise I would also like to only allow a couple inbound routes from area 0.0.0.1 into area 0.0.0.0. Looking at the documentation I see how to suppress routes from area 0.0.0.1 but not the other way around. Is this supported? I'm a bit confused and would like some insight into this.
Thanks,
- Cannot ping interface, IP or defaul gateway from PA 500 to Cisco switch in General Topics
- Cortex XDR PoC Lab ft. CVE-2021-3560 in Cortex XDR Discussions
- how to suppress the prompt "Cortex XDR" would like filter network content" in Cortex XDR Discussions
- PAN-OS 10.2 : filter incoming OSPF routes in General Topics
- Properly routing IPv6 across site-to-site IPSEC tunnel in General Topics
Show your appreciation!
Click Accept as Solution to acknowledge that the answer to your question has been provided.
The button appears next to the replies on topics you’ve started. The member who gave the solution and all future visitors to this topic will appreciate it!
These simple actions take just seconds of your time, but go a long way in showing appreciation for community members and the LIVEcommunity as a whole!
The LIVEcommunity thanks you for your participation!
