Replacement PA-500

Does anyone know where I can buy a replacement PA-500? I have one that failed on Saturday (won't power on) and PA Support is dragging its feet on approving a replacement. They said:

I have submitted the RMA request and you are entitled to next busine

Panorama ISP redundancy

Hey

I have a situation that my main site has 2 ISPs i configured the remote PA to talk with panorama thought the External Interface in order to maintain connectivity even if i have problems with the internal network on the remote site.

I would like t

PAN-5060 Fans running at Full Speed

My 5060 fans are running at full speed at all times. I attempted to run the follow command "set system setting fan-mode auto" in Operation and Configure mode and it will not work. Getting the "invalid syntax" error.

Any thoughts???

DHCP Relay source Interface

Hi all,

We're having some difficulties with DHCP Relay on PA 7.0.5.  Our setup looks like this:

 Client <-> L2 SW <-> PA <-> L3 SW <-> DHCP Server

We use a VLAN sub-interface on the PA as the default gateway for that subnet and I configured DHCP Relay

mismatch of static-ip source translation address range between original address and translated addre

getting  error mismatch of static-ip source translation address range between original address and translated address 

Error failed to parse nat policy

NAT Policy is

SRC Zone : Outside

DST Zone : Outside

Original Packet : SRC address - Public IPs

Origina

Question about application group and custom service group

Hi All, 

First off I appologize if this question has been answered before.

I have a question regarding the use of application groups and custom service groups in the same security policy. Can traffic identified in the application group use a non stand

Warning on commit new config - anyone recognise the cause?

Folks.

I made a rule change this morning - first one in a while (fairly static environment of late) - and when committing, got the following warning

Error: Invalid id 6 for os WindowsUWP.(Module: useridd)

Anyone recognise this/know the cause/know wha

Cannot enter "Maint" at boot via cli

All,

somehow I lost connection to my PA-200. Im trying to do a factory reset on it and I am not able to enter 'maint" during boot via console.  I am using putty .  When I try, it just keeps loading the kernal.  is there a way to pause to enter "maint

I'm getting an error when trying to log in maint mode on PA-2050

I have an Evaluation unit that I'm trying to reset to factory defaults via the Maint Partition, but not having any luck.

Here is the error message I'm getting after I type in 'maint' at the prompt...

Autoboot to default partition in 5 seconds.
        E

U-Turn NAT with Port Address Translation in a DMZ

Hi Community,

I am configuring my first PA-200 and having a difficult time. I have a /27 external network and have the PA-200 seeing the internet properly. I have internet untrust zone setup as l3 on Int 1.1, and a DMZ setup as l3. The DMZ zone is on

Priority in PAN-QoS

Hi, 

When you are configuring QoS, it's possible to define more than one profile, and in this profile put 'til 8 Class defined. 

When you apply over the egress interface, it's possible to add this Class based over an source Subnet.

Here is my questio