Resolved! Port Move - Using Panorama Templates

Hi Folks,

I need to do a port move on a 3220 - RJ45 to an SFP port - part of an ISP upgrade. Everything else remains the same.

The trouble i have is that all the config is managed from a Panorama Device group. I don't know of a way of editing the vari

Resolved! QoS either on Sub Interface or Vsys

I have 24 VSYS on the Firewall,

All of them are using the same physical interfaces for incoming and outgoing traffic but different sub-interfaces.

I have decided to apply the QoS profile for egress traffic. As I know I can apply the QoS on the physica

Resolved! Firewall log storage quota related

Hi
I have a question regarding log quota.

You have set the firewall's configuration related log quota to a minimum.

Immediately the logs were reduced to a minimum. (Approximately 500 lines)

After that, the logs are stacked, but the previous logs are not

Resolved! PBF conflict with "ip strict option" in zoon protection

Hi All

i have a scenario where the traffic works fine if it's forwarded by the routing table (and nat is applied)

when i used pbf, it didn't work, checking global counters i found oacket are dropped and the reason is "strict ip" option in the zone prot

Resolved! Routing between overlapping networks

Hello,

I want to replace our existing firewall with a PA-850. Thereby I have a problem, which I cannot get solved.

I have to route to an external network, which unfortunately uses the same subnet as ours.

Until now, I have used a small Linux VM, which u

Resolved! SCCM management of remote GP Windows clients

We just deployed and started using GlobalProtect 5.1.1 to support the work-from-home COVID-19 initiative for thousands of remote workers.  Everything is working well but my SCCM guys can't manage any of the remote clients to push patches or software

Resolved! route-table unicast appear after adding new prefix in BGP export filter

Hi,

We have an existing BGP peer session to our service provider advertising a few prefixes which has been working fine.  I have recently added a new prefix (/24) which statically routed to our internal switch, all our static routes are redistributed

Resolved! Help with routing decision

Hi

Got BGP providing DGW and I have a static 0.0.0.0/0 with metric 240 so its last resort route

but

VIRTUAL ROUTER: vr_default (id 2)
==========
destination nexthop metric flags age interface next-AS
0.0.0.0/0 0.0.0.0 19 ~
0.0.0.0/0 202.74.32.69 ?B 612028